Apexi GT FMIC Install - Cutting?
 

Guys,

Manual shows I need to cut to install the FMIC.

Do I have to ??

Manual...

http://img577.imageshack.us/img577/2373/apexicut.jpg

Found this on the forum...

http://img7.imageshack.us/img7/8628/enginejw.jpg

http://img827.imageshack.us/img827/9...talledrear.jpg

Do I have to cut something on the car to make it fit on the right FMIC side ??

Thanks..!!!

The first engine bay pic you posted is a greddy m-spec.
regardless, you do need to cut that one little piece IIRC.

Really ?? Cutting my 7 ?? I don't think so, I'll try to do it without cutting... Hope it works...

i dont believe you have to cut the frame, if its a front mount on the stock bumper you will have to do some cutting to make the intercooler fit.

I have that IC, there's no way in hell it's going in without cutting. That part isn't structural, when you see it it's a pretty non-substantial piece of the car. I just cut it out, then primed and painted it to keep rust away.

That's about the least amount of hacking to get a front mount in the car. You have to hack up the bumper and bumper support big time to run the Greddy. If you don't want any cutting, only way is a stock mount IC.

Dale