10.1 cm from bottom of housing to center of roll pin which appears to be located in the center of the port. maybe it is 10 but on my vernier caliper it shows 10.1

dang, hate not being able to delete a mispost

thank you Howard

don’t have a loose 13B-REW engine handy and need some assistance with the vertical dimension between the upper exhaust manifold mounting hole centerline and the lower intake manifold mounting hole centerline


https://cimg1.ibsrv.net/gimg/www.rx7...6d76e1a94.jpeg

need this to build a jig plate that will let me bolt the intake and exhaust manifolds to it in lieu of an actual engine.

TIA.
.

As measured it looks to be 1.412 +/- 0.002”, about .005 shy of 36mm.

36mm it is, thank you good sir

.