RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Where to shift lever assembly and reverse light and fifth gear switch (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/where-shift-lever-assembly-reverse-light-fifth-gear-switch-810569/)

jetskii4lyfe 01-03-09 03:43 PM

Where to shift lever assembly and reverse light and fifth gear switch
 
90 convertable. Any suggestiongs for these two parts? Shift lever assembly and reverse light and fith gear switch. Also, places to order parts from. The local car part places do not carry certain things.

RxFuel 01-03-09 03:56 PM

For parts I would either hit the for sale parts section of this forum, but if you need new I would go to mazdatrix.com they have everything you will need usually

vrracing 01-03-09 08:49 PM

You're looking for the parts on the Auto Tranny?

vrracing 01-03-09 09:25 PM

nevermind. The auto is a three speed.

If you're looking for JDM ones from a swap that's tough. My engine came with a 5-speed and the reverse switch was broken off. Atkins sold me one from his junk pile but it wasn't even close to being big enough. ended up fabing a switch using a push button switch I got at Frys and putty-style epoxy.

I'm betting with as much as you need you'll need a whole new tranny.

vrracing 01-03-09 10:03 PM

And I didnt hook up the 5th gear switch as per the a/t to 5-speed swap writeups.

toplessFC3Sman 01-04-09 10:46 AM

if you have a non-functioning but physically intact 5th gear/reverse you can just open it up and clean it and it should work. i did this on the switch on my turbo trans and it now works fine

jetskii4lyfe 01-05-09 08:31 PM

if a wire is broken off, is it possible to sodder it back on if i tear it apart?


All times are GMT -5. The time now is 09:00 AM.


© 2024 MH Sub I, LLC dba Internet Brands