2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

weird electrical problem

Thread Tools
 
Search this Thread
 
Old Jun 21, 2004 | 01:33 AM
  #1  
NArotaryfan's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: May 2004
Posts: 18
Likes: 0
From: socal; california
weird electrical problem

car started fine, as in it cranked over fine, and then suddenly one day i go to start it and it wont turn over.
so i get a jump start but the added juice doest do anything it still turns over very slowly like its dead. i diagnose it as a bad started cuz i can hear the solenoid clicking. so i but a new started i put it in and turn the key and starts right up. then drive it bring it back call it good. then i go to start it up again same symptoms as before
any ideas?
bad ground? bad battery?, i did a basic test at first-consisting of putting in someone elses battery out of a new car i didnt have it tested or load tested cuz it was stuck and needed it fixed asap.
Reply
Old Jun 21, 2004 | 01:49 AM
  #2  
Parastie's Avatar
Mountain Rotary Mod
Tenured Member 05 Years
 
Joined: Nov 2003
Posts: 2,411
Likes: 0
From: Freaking Poland!!
take your battery and alternator to a local autozone and have them tested.
Reply
Old Jun 21, 2004 | 08:31 AM
  #3  
SureShot's Avatar
Seduced by the DARK SIDE
Tenured Member 15 Years
 
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
The next time you try to start & it fails, feel the primary cables for a hot spot caused by a weak connection.

A cable can look good but have corrosion under the insulation.
Reply
Old Jun 21, 2004 | 12:54 PM
  #4  
NArotaryfan's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: May 2004
Posts: 18
Likes: 0
From: socal; california
thanks to the forum i figured it out. turned out that a couple of weeks ago when i had it in the shop a mechanic took off the ground that bolts to the tranny and didnt put it back so it started when it happened to rub against the block otherwise it was just hanging and the startings system acted dead.
thanks
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
firzen
2nd Generation Specific (1986-1992)
9
Sep 15, 2015 12:04 PM
ZaqAtaq
New Member RX-7 Technical
2
Sep 5, 2015 08:57 PM




All times are GMT -5. The time now is 10:18 AM.