TII Tranny Install Problems
 

So I sold my spare jspec transmission from a S4 13bt to a guy.

He's installing it on his 87 TII, he says it's the wrong one, bellhousing bolts don't line up, tranny mount won't line up, and when he had both of them together(his old one and mine) he says that mine was taller.

Any ideas? I took the transmission off the engine that's in my car right now and it bolted up.

should fit, i have a jspec tranny on my S4 13bt.

???? mine's an 88 tho, but shouldn't matter

.

should fit no problems at all.

Matter of fact I believe even a GSL-SE transmission should bolt right up, and even a 12A transmission.. but don't quote me on that.

maybe hes putting it on upside down

What bellhousings are different than another?

What bellhousings are different than another?

sounds like the guy has no business working on an FC if he can't get the tranny to go on.

Which driveshaft is longer, and which is shorter?

the n/a driveshaft is longer... the TII is shorter(is that what you were talking about?)... it should bolt right up.

Tell him to stop trying to put that V8 into his RX-7...

Seriously, all the 13B's should fit and swap transmissions.
Hell, I think all the 12A's will fit too.

It's either he has the transmission wrong, he's not using a rotary engine, you sold him the wrong transmission, or he's just an idiot.


-Ted

I highly doubt I sold him the wrong transmission, I took the transmission off the engine that I've installed in my car(10th AE) and that engine bolted up to my car just fine...

Maybe he has it upside down?

Steve

74-04 is the same bellhousing bolt pattern.....
except the 89-96 cosmo and auto fd

so if it came out of mazda rotary car then it should fit in mazda rotary car

mike

whoops, bad mouse!