RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Severe hesitation / fuel starvation at 3500rpm (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/severe-hesitation-fuel-starvation-3500rpm-824520/)

REVERE 03-07-09 03:17 AM

Severe hesitation / fuel starvation at 3500rpm
 
Driving home from work last night, about 3min into my trip I rounded a corner started to come up to speed and the engine just about died on me.
Upon further experimentation I found the engine was hesitating at 3500rpm both off and under load and the idle is slightly rough.

I have searched extensively and found many similar threads that present a few solutions (injectors, vac leak, exhaust leak, grounds).
Currently I am working on the theory that the secondary injectors are to blame.

If you have any suggestions as to a possible cause, I would greatly appreciate hearing them.

MmSadda 03-07-09 09:33 AM

Search 3800 Hesitation.

REVERE 03-07-09 11:39 PM

Definitely not the 3800 hesitation,
I probably did not explain the problem too well. The engine will not rev over 3500 at all; it is not just a little lag kick at 3800.

Marshessn 03-08-09 10:45 PM

car series?

omp limp mode?

REVERE 03-09-09 08:42 AM

1 Attachment(s)

Originally Posted by Marshessn (Post 9028174)
car series?

omp limp mode?

J-spec 1990 (August) S5 turbo ~80,000 original km (50,000 miles)




Flawless operation for the last 4 years, not a single problem at all only mods (that I know of) are:
  • Trust exhaust
  • Trust Airinx air cleaner
  • Tanabe Strut tower braces
  • 17" Volk GT-C’s 8” rear, 7” front with 245/225 Dunlop direzza’s
Probably a few other bits and pieces, but I haven’t really had a need to pull things apart to check.
Car is going to my mechanic tomorrow, as I don’t have the equipment to diagnose this problem. I will post the resolution once I know for future search purposes.


https://www.rx7club.com/attachment.p...1&d=1236605896

J.MurdaFCs3 03-09-09 10:24 AM

nice tII. I bet you your relief pressure hose to the valve came loose. easy fix. it goes from under the acv(off the uim) to a air chamber(plastic bulb looking thing). check it before you go spend tons of money on a mechanic. pm if you have question about what im saying. Ive had this problem in the past. in fact I think Iv had every problem and fixed them all. good luck

jjmcgee 04-07-09 10:52 PM

I had a similar problem turned out to be tps

freemanrx7 04-08-09 01:27 AM

Catlytic coverters?

slpin 04-08-09 04:33 AM

Rip in TID by turbo
BOV isnt in place
A chip in the AFM
hell could even be a bad plug
pressure sensor vac line fell off?
tps bad? disconnect and drive it?

Hesistation off load? how?

ya, could be anything


All times are GMT -5. The time now is 11:33 AM.


© 2024 MH Sub I, LLC dba Internet Brands