rear iron water temp sender question.
i searched up and down, but oddly enough, there isnt any more info on this component other than its there.
where does the wire it hooks into go to? i recently did a t2 swap and the wire is now gone. does it connect to a black single wire connector under the two coils close to the firewall? anyone have thread information on this by any chance? |
I believe it connects to the Sender which is under the Oil Pedestal. In That area also you will find the oil temp sender(N/A anyhow).
|
It connects to a single YELLOW wire (yellow / red or yellow / white), which snakes into the main engine harness.
-Ted |
Originally Posted by RETed
(Post 8068758)
It connects to a single YELLOW wire (yellow / red or yellow / white), which snakes into the main engine harness.
-Ted |
It goes into the crossover plug that's located in the passenger side kickpanel.
There's two plugs there, but there's only one yellow wire. Just splice it into that wire, and your stock water temp should work. I've explained this MANY times in the Haltech section. -Ted |
All times are GMT -5. The time now is 05:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands