RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Rad exploded, now won't start. O-rings and compression fine. s5 NA (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/rad-exploded-now-wont-start-o-rings-compression-fine-s5-na-883779/)

ifryrice 01-28-10 07:44 PM

Very likely, and your original mix was watery enough that it began freezing, so it could just be burn-off from some undisclosed location. Whenever you get the FP stuff figured out, that should be easy enough to diagnose. At least, if the temperature starts going up.

Amur_ 01-28-10 07:46 PM

At this point, I think that unless the system fails again before I replace the FPR and COR, I'll never really know what failed. I can live with that, as long as the damn car runs properly. :)

ifryrice 01-28-10 07:52 PM

Until the day that it just randomly stops again... That's what sucks about these kind of things. Maybe it just doesn't like the cold. At least we know where the problem is in not so many words.

A)Wiring
B)COR
C)FP R/R (tested fine with voltage test, so, probably not this, but who knows maybe that was a time it'd have started?)

jjcobm 01-28-10 09:07 PM

Well if the engine bay heats up, it should thaw everything out : )

Glad your back on the road

Amur_ 01-28-10 09:14 PM


Originally Posted by jjcobm (Post 9769128)
Well if the engine bay heats up, it should thaw everything out : )

Unless some of the slushy/frozen 'blockage' is still in there. That's another reason I won't be moving her right away, and why I was repeatedly checking my digital temp gauge after starting her earlier tonight. Too many uncertainties around what happened that morning. I'm gonna take small steps until she's clearly ready for more. She didn't even get up to operating temp (161F,) although she did run longer than yesterday. I'm gonna run her again, let her warm up and then just sit and idle while I watch things like a hawk.



Glad your back on the road
Thanks. :)

RotaryEvolution 01-29-10 12:07 PM

not all coolants smell the same or even like coolant at all when burned. don't rule out that it couldn't just be a bit of coolant that is sitting in a pool on or near the exhaust that is cooking off. most coolants i can sniff the exhaust for, others i have started to choke and have my eyes burn even standing 10 feet away and they weren't running that rich but did have coolant seal failures, that i was trying to identify.

i would still suggest blowing things out with compressed air if you can get it somewhere where you can do this. coolant won't evaporate like water will even when the engine bay temps are at normal, so it can sit in electrical connectors for quite some time.

Amur_ 02-03-10 04:52 PM

She has yet to not fire up normally every time I've cranked her. :)

The next time I started her, that mystery steam/smoke didn't appear. I think that it was standing water and the heat from that first warm-up was enough to eliminate it. I've had identical steam rising from the rad each time I've let the engine warm up enough and I believe I'm seeing the same thing.

I discovered that the coolant overflow tank contained a nice chunk of ice (duh,) which further explains the explosion - the system might have otherwise vented to the tank until it was critically low on mix. Instead, KABOOM.

She seems to be running perfectly normally. The e-fan kicks it when it's supposed to and I haven't spotted any leaks or oddities. I guess we're done here.

Thank you to all who replied and offered input. Even the grumpy ones. ;)

ifryrice 02-03-10 05:33 PM

It's about time you responded, I was getting a little kim jong ill up in here waiting for the news.

Amur_ 02-03-10 05:37 PM

You can relax. Kim Jong is Ok. ;)


All times are GMT -5. The time now is 06:44 PM.


© 2024 MH Sub I, LLC dba Internet Brands