PIX from stage one of TII project
 

pix from today spent about 2 hours and did all this....
http://www.vosko.net/photos/T2/stageone/t2apart-1.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-2.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-3.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-4.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-5.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-6.JPG
http://www.vosko.net/photos/T2/stageone/t2apart-7.JPG
hopefully pulling engine this weekend :)

i got a big lead on you. :D



http://www.2751engineering.com/13BRE.jpg

yeah seth i know your winning so far. but i have a FAR easier job ahead i think sorta ;)

ah good, but where is fd?

Everyone pulls their engines the hard way.

i own a FD ? ;)

Vosk were going to have very similar setup's

Let the E.T race beggin when were both done :D

Here is my Stage 2 plans: (stage 1 was mild port 3"exhaust) everything else stock = 13.5@105
(my engine is broken too but at the shop now)

Full Street Port
850cc Secs
stock Turbo
upgraded ECU :D
SX FPR
Walbro 255 FP
BOV
POV
----------------- 1/4?
then later after the car is tuned and see what she runs with stage 2

Stage 3:
TO4E Stock Turbo Upgrade
550cc x2
850cc x2
1600c x2
NPR FMIC
SX FPR
walbro FP

YO BASTARD - got the cosmo 13b-tt in there.

well mods for right now are gonna be street port, fmic, bigger secondaries, already have ecu. i think some other goodies too :)

see very similar hehe

well except you got a S5 engine that has the bigger factory ports :(

you better hope i don't go nuts and get a 13B-RE those have GIANT PORTS :D

way to go vosko! i knew you could do it. keep on tearing her down and learning it's the best way!

i need to rent a power washer the entire engine bay is filthy!

Go to autozone and buy some Simple Green foaming cleaner... its in an aerosol type can. Anyhow, don't get it on your engine (simple green is said to etch aluminum), but everything else in there can get a nice thick coat of it... then just use a hose to wash it off... you will be VERY surprised how well this works...

It worked better than the power washer did on mine.... Next time, I'll simple green (the foam stuff) the engine bay, and then power wash it off.

SWEET. i'll try that once the engine is out! more stuff on my list of crap to do. remove ac, remove abs....

i think i might go CYMFC3S style and run 1600cc secondaries on the stock computer :D

i think its time to finally signup for mazda comp too ;)