Need stock badge placement!
 

Hey i just ordered in the Mazda and Rx7 badges from mazdaspeed and im about to run over to the mazda dealership to get em put on properly.

Do they have the measurements? If not please post.

http://img266.imageshack.us/img266/9895/picture9mz0.jpg

rx7 goes on the left , mazda goes on the right

Yea no kidding i need the measurements so it doesnt look bad.

here like this, the dealer told me that how they went when I bought new badges. I cut the little mazda off the rx7 sticker, didnt like the looks of it being it says mazda on the right side.

Chris

Do you know how much they charge? If its gonna be over 50 ill be pissed because for starters i paid 50 for the badges and 40 for frickin shipping to bc from cali.

Ok just went out and measured here you go From the right edge of the 3rd brake light, the edge of the M is 13.25"/ From the left edge of the 3rd brake light, the top edge of the 7 is 1'3/8" and 1" from the lights to the bottom of the badges!

Hope this helps

Chris

I paid 20 bucks from my local mazda dealer for the 2 stickers total!!

Thanks a million man, ill get some pics up of the placement when i get back. Again thanks!!

Are you for real? Aww man, mazdaspeed is a joke.

NP glad I can help

do you have the holes for them or do they need to be drilled?? i bet there gonna charge you atleast 100 if not 2

DO IT YOURSELF! It's not that hard man, save you some cash. Take it to a car audio shop or something. We charged this guy $35 to debadge and rebadge his 350z as a Fairlady. Took us about an hour. I'm sure another shop would do the same.

Thanks for the advice.

I went to the dealership to see if they could do it and they were busy. I was directed to a body shop and i talked to the guy there and showed him the emblems. He said not to drill holes for my emblems and just cut off the studs and glue it real good then just stick it on the back of the car. Reason for it was because he said rust would probly start in that area if i did it. But i think im just gonna go with how the emblems are made and drill holes. What do you think?

seeing as this is almost current and you never got an answer, I'd say do glue. the body shop guy is right, unless you seal carefully with grommets, paint or primer, and other sealer like RTV then it would probably start rusting.

I plan on getting new emblems/badges soon, but I want to see if the new Mazda 'M' would work nicely or not. I really like it, finding good locations for it is the trick... anyone have pics?

i would have hoped he got them put on or something three months later.