Injector Installation
 

Hello All! I am seeking a write up and diagrams for a injector install for a 87-88 t2, I know i will need the O-Rings and grommet. I hear its pretty simple process after removing the intake tube, but I would prefer not to destroy anything in the process =], any help would be greatly appreciated so i can do this now and in the future! thank you in advance.

Have a good hard look at the relevant pages in the FSM (go to http://www.teamfc3s.org/main/factory_service_manual and download if for free if you don't have it). Start from page 4B-73 in the Fuel Systems chapter. Familiarise yourself with how it all goes together so you know what to expect when you take it apart. It's actually pretty easy and self-explanatory once you get into it. Don't remove the air bleed sockets unless you have to. They break easily and they're not particularly cheap.

OK since im doing the exact same thing right now. Of course mine is the from hell version.

Use NZ's link above and down load manual.

then use this

http://fonglingling.tripod.com/zenkifc3s/id8.html

For when you are ready to test them


https://www.rx7club.com/2nd-generation-specific-1986-1992-17/new-injectors-leak-test-540464/

Dont forget to get the gasket for the UIM to LIM just in case. Check all your hoses too. Fuel, vacuum etc....

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/replacing-injectors-s4-turbo-539613/

this might help..ima be doin mine in a few weeks