Apparently when the engine was swapped out of my 7, then didn't feel the need to use all the bolts when attaching the bell housing to the engine. So when I went to install my racing beat engine torque brace, there was no bolt to bolt it on to.

Does anybody have one laying around? If not, does anybody know what size stud/bolt this is?

I reached down to where the stud is supposed to be, and all I felt was a threaded hole... yeah, nice.

Any help is appreciated. I have the service manual, but I see nothing about bolt/stud sizes.

 

if i can remember its a 14mm

 

Mazdatrix- give 'em a call, or go down the pricing list on their website- it's in there somewhere. If I understand correctly, you need the stud (top of tranny, right?)

 

yeah i think it's 14mm with 1.25 pitch or something.