Idiots guide to pilot bearing removal
#35
Lives on the Forum
iTrader: (7)
Well, I got a bit sidetracked last night, so heres the pic. The two arms fold flat, easily allowing them to fit inside of the bearing. You just turn the black screw thing at the top and it opens the two arms up. Once they are in place, you place the big U-shaped brace on the flywheel and tighten down the nut. As you continue to turn the nut, it pulls the arm assembly out. It took a few trys to get right, but did the job without drama.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM