RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   How hard is it to replace water pump (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/how-hard-replace-water-pump-72109/)

tmak26b 04-17-02 10:53 PM

How hard is it to replace water pump
 
How hard is it to replace the water pump on a 90 NA? Should I just get the pump or get the housing too?

NZConvertible 04-17-02 11:32 PM

Re: How hard is it to replace water pump
 

Originally posted by tmak26b
How hard is it to replace the water pump on a 90 NA? Should I just get the pump or get the housing too?
Go to www.fc3s.org and find out for youself! :D
It's under How-tos, Engine.

Nimisys 04-18-02 12:51 AM

its easier than just about every other car out there...

basically you pull the battery, fan+cowl and move airbox out of the way. then you remove the belts and hoses pull the altenator and air pump and pulleys, then remove pump and housing... replacing the housing to block gasket is pain ( trying to scrape the surface but keep things out of the engine is a bitch). reassemble in opissite order.

not to bad at all and follow service manual and you;ll be fine

KNONFS 04-18-02 08:49 AM

Very easy to do, the hard part is takig off the old gastket (just like Nimisys said), however I don't remember removing the alternator and air pump, but you do have too remove the escentric shaft pulley ;)

It takes an hour if you have done it before!

KNO


All times are GMT -5. The time now is 07:24 PM.


© 2024 MH Sub I, LLC dba Internet Brands