Guess that Rwhp
Since i cannot afford to dyno right now, i want to get an idea of what my hp would be. im runnin...
an 87 T2 engine with a street port, 3mm ceramic seals, front mount intercooler, Turbo smart BOV, stock turbo, no cats. k&n cone intake. im working in getting the rest of the parts, boost controller, FCD, new turbo,injectors, fuel pump, etc. So what do you think this setup would put out? |
7.5, if you're lucky.
|
3mm ceramic apex seals with stock turbo? I don't really understand the point here... but since you still have the stock exhaust and intake TID... i'd say you don't have very high gains... begin by the full exhaust system and TID, you'll get such a very noticeable HP gain, but don't forget to port your WG.
|
180-190
|
gulp, 180-190...... i was hoping for at least 210... at least. wow, are u serious?
|
Originally Posted by PX Brotherhood
gulp, 180-190...... i was hoping for at least 210... at least. wow, are u serious?
|
That and stock boost... Your car is basically the same as a stock TII, you just don't have cats, that's 200bhp for a s5, remove drivetrain loss, and add a little for the no-cats, and that's about where you're at.
|
what about me? 3" TID, corksport 3" turbo back exhaust, 255 walbro fuel pump, MBC, HKS FCD, turbo XS BOV, fuel relay resistor, s4 motor with s5 manifold/turbo
|
220-250 seems the typical number for a good stock turbo setup.
|
You guys talking rear wheel or flywheel hp.
|
if you don't get a FCD that front mount will be the cause of your blown motor.
|
All times are GMT -5. The time now is 09:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands