RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Coil resistance value? (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/coil-resistance-value-532979/)

rurouni2071 04-23-06 05:36 PM

Coil resistance value?
 
My car has been having problems after it warms up , anyways I checked the resistance after it warms up and dies I checked and the leading was 0.6 and the trailing was 0.9 and 1.1 the FSM says 0.2 -1.0 and anything over to replace but I Was wondering if that would cause the car to die once warmed up to just avore normal operating temp?

rurouni2071 04-23-06 07:51 PM

help ..? lol

rurouni2071 04-23-06 07:54 PM

I know that one of them should be replaced , but would my trailing coil being out cause my car to die ?

HAILERS 04-23-06 08:43 PM

It isn't the coils much less the trail coil assy.

It's a car with an improperly set idle/timing/tps. TPS last of all. And or the BAC isn't working right. See the online fsm for how to set a proper idle.

And before you ohm anything out, put the meter leads together and read the reading. Subtract that from whatever your going to measure for a more accurate reading.

rurouni2071 04-23-06 10:47 PM

it runs beautifully at start up , after a few minutes the idle falls to a steady 750 but after say 20 minutes of running the idle starts to waiver , then if I rev it gets stuttery and after a few minutes sitting at idle it dies
i pull my plugs and they're wet and I can smell fuel in the exaust... what do you think?

rurouni2071 04-25-06 09:37 AM

I took the ecu out and it was getting really hot , but when i move the wires in the harness around , all my relays flicker and my gauges mess up , that and my car gets so rough it dies , ll i think I found my problem


All times are GMT -5. The time now is 12:55 AM.


© 2024 MH Sub I, LLC dba Internet Brands