Clutch master cylinder bleeding problem
My clutch master cylinder went out(pressure was bleeding off), so I pulled one off of another rx7 while I wait on my rebuild kit to get here. I bolted everything up, but when I went to bleed it, it wouldnt draw fluid from the resevoir. Ive tried everything, even using a mityvac, nothing works. I was messing around with the old master cylinder after I took it off, and noticed it was doing the same thing, even though I had bleed it several times without incident before taking it off. What the hell is going on? Is there a special way you have to bleed it first?
|
Sounds like the drip/supply hole in the top of the cylinder is blocked. Remove the plastic reservoir and clear it with a pin or paper clip. Compressed air is good, too, if you have it. Also be sure that the bottom of the reservoir itself is open.
|
First loosen the fitting on the master to get it primed.
Then tighten it & open the slave bleed. It's possible to have a bad line. |
All times are GMT -5. The time now is 05:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands