13BT + TII tranny + Automatic n/a driveshaft + N/A LSD = ok ???
 

13BT + TII tranny + Automatic n/a driveshaft + N/A LSD = ok ???
Is it a possible combinaison ?

yes its possble but i would not advise it......first of all the N/A driveshaft would snap under the contstant pressure of boost......GUARANTED... so it would be better to order the turbo 2 driveshaft and lsd or get fromt the infamous car graveyard

The only reason you should ever use this setup, is if you MUST have the car to drive around from work/etc, and even then, be DAMNED sure to take it easy, otherwise you'll snap that thing right off.

hahaha tnx guy for the advise! Cause right now i run my TII driveshaft bolted with only 2 bolt to the companion flange for work and test the new engine swap... ill take it easy!

Ill put my TII differentiel next week..


TNX !

how much does that driveshaft actually touch the spines... 1/2"?, 1"? 1/4"?... I'm curious

it slides in a good 3-4", it's only about 1 1/2" short, but it's just too damned skinny to take much abuse.

ahh, hmm tx

it will work but not for long.....I was thinking of doing this(NA AUTOMATIC DRIVESHAFT) so I could use the GTUs 4.3 rear end with the TII engine/tranny but once I saw the size differences I decided not to use it....you can see that the TII parts are much stronger than the NA....