RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   ***Power Loss/SEARCHED*** (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/%2A%2A%2Apower-loss-searched%2A%2A%2A-649191/)

nairdalavodnas 05-03-07 01:05 PM

***Power Loss/SEARCHED***
 
so today i was driving and this happened to me,


I'm working on buying a '90 N/A, but there are a few quarks ..

One of which, I can't figure out ..
After driving around for a while, I will experience a power loss .. anything above 3000-4000 RPM doesn't really give any power at all, and sometimes it won't go above 3000 RPM .. occasionally the check engine light comes back on .. but if I turn the car off and start it again the problem goes away .. even if I turn it off and back on in motion .. 3 seconds of 0 RPM solves it and it won't happen again for hours..



the only difference is i have an 87 n/a and it wont go above 2000 rpms. and when its in not in gear and im flooring it itll hold a steady feather and wont go above 2000.


any one know where i can get my ecu checked at? im in san diego


the font in red is what i found when i searched

Chuck 05-03-07 01:43 PM

If the CEL comes on you should be able to pull the code and that can help lead you to the problem. Secondary injectors kick in at about 4K so it sounds like there might be a problem there.

InsomniacFC 05-03-07 01:46 PM

Clogged cats?

nairdalavodnas 05-03-07 01:59 PM


Originally Posted by Chuck
If the CEL comes on you should be able to pull the code and that can help lead you to the problem. Secondary injectors kick in at about 4K so it sounds like there might be a problem there.


cel?....

Porchapa 05-03-07 02:03 PM

Sounds an awful lot like a fuel problem... Chuck is right the injectorys DO kick in AROUND 4.. but even if they were badly mistimed they wouldn't kick in at 2......have your comp checked, pull the code, and CHECK YOUR FUEL FILTER.. thatll do it every time

unW7WZ 05-03-07 02:41 PM

CEL= Check Engine Light. Same for MIL. = Malfunction Indicator Light.

My5ABaby 05-03-07 02:48 PM

He has an S4, there is no CEL. However, you can check for error codes.

http://fc3spro.com/TECH/HOWTO/ERRORC...KI/zerror.html

nairdalavodnas 05-08-07 03:33 PM


Originally Posted by My5ABaby (Post 6910474)
He has an S4, there is no CEL. However, you can check for error codes.

http://fc3spro.com/TECH/HOWTO/ERRORC...KI/zerror.html


SOOOOOOOo i made one of those little things, and it pulled up nothing. i have no immidate failuers. umm what should i look for in my fule filter, rust? and it started doing it agian to day after not doing it for about aweek. Could it be the weather? because although the temp gauge say in running normal, could it just be running hot, and yes my temp gauge works properly. and i notice its does this on hot ass days.

red_s5_fc3s 05-08-07 06:29 PM

I had the same problem. At first I thought it was hesitation so I cleaned all the grounds and replaced the fuel filter. It helped, but the problem started to sound like the same one you experienced in the red font. I went to and exhaust shop and replaced my cat. After pulling the old cat I shook it around and it sounded like a golf ball inside a coffee can. So to answer your question, it is most likely due to a clogged cat. Either punch it out, get a new cat, or just cut it out and weld in a straight pipe.

nairdalavodnas 05-08-07 06:52 PM


Originally Posted by red_s5_fc3s (Post 6920587)
I had the same problem. At first I thought it was hesitation so I cleaned all the grounds and replaced the fuel filter. It helped, but the problem started to sound like the same one you experienced in the red font. I went to and exhaust shop and replaced my cat. After pulling the old cat I shook it around and it sounded like a golf ball inside a coffee can. So to answer your question, it is most likely due to a clogged cat. Either punch it out, get a new cat, or just cut it out and weld in a straight pipe.

im acctually gonna get a new exhaust. next week most likely. by 12**31 motorsports. its gonna be custom 3 inch piping from the header to a megan racing muffler

red_s5_fc3s 05-08-07 07:11 PM

Do you have a catalytic converter on right now? Will this setup replace the old cat? If so, this should solve your problem. If not, it will most likely make some kind of difference and we can asses the situation from there. Good luck, and I hope it fixes all your problems!

nairdalavodnas 05-08-07 07:33 PM

yah i have a stock system on right now.

nairdalavodnas 06-03-07 08:45 PM

I Wanna Punch A Child
 
Soooooooooo I Got A Custom 3 Inch Exhaust From 12***31 Motorsports. And I Was Driving To Mybrothers House To Day And My Car Is Still Fucking Doing It. Some One Please Helppppppp

Icemark 06-03-07 11:01 PM


Originally Posted by nairdalavodnas (Post 7006146)
Soooooooooo I Got A Custom 3 Inch Exhaust From 12***31 Motorsports. And I Was Driving To Mybrothers House To Day And My Car Is Still Fucking Doing It. Some One Please Helppppppp

Three inch exhaust is over-sized for a non turbo, and will probably result in less power through the hole power band.

Power loss can be from all kinds of things. A clogged cat, a mis-adjusted TPS, dirty fuel system, Bad spark plug cables, mis-tuned timing/ignition.

These are all pretty basic that even the most simplest mechanic should have figured out.

Your bumps in this thread have been deleted. Bumps are forbidden here in the 2nd gen RX-7 technical section.


All times are GMT -5. The time now is 02:24 AM.


© 2024 MH Sub I, LLC dba Internet Brands