Engine wiring
I bought an engine with a custom left side harness and adaptronic m1200, the guy I bought it from says I won’t need my old left harness but my concern is what’s inside on the harness it splits into two different boxes under the dash do I need to splice these into the new harness or don’t need them? Anyone know what these boxes are underneath thankshttps://cimg2.ibsrv.net/gimg/www.rx7...5b72dc226.jpeg3 connectors to the old ecu. 1 is goes the the harnes on the left (if you’re sitting inside) and two on the right harness https://cimg4.ibsrv.net/gimg/www.rx7...acbc4e40e.jpegThe harness on the right splits into a few boxes here. One is that grey one and two yellow ones not pictured https://cimg6.ibsrv.net/gimg/www.rx7...d4e9afd1d.jpegHere are the connectors under the console you can’t see https://cimg7.ibsrv.net/gimg/www.rx7...89feec6d5.jpegThe new engine has the following: Fpr2000 w/fittings (parallel) system, Fp sensor ($105 from turblown and used with a plug on one of the ecu output), Mtxl plus wideband, Modular m1200 ecu, Dr-25 sleeved engine harness, Aem smart coils, Custom plug wires, Upgraded temp sensor |
All times are GMT -5. The time now is 03:59 AM. |
© 2024 MH Sub I, LLC dba Internet Brands