Carburetor Conversion 6 port
Today I picked up a 13b series 4 that has been converted to carburetor (6 portintake manifold). upon assembly I found that there are some hooks on my air intake manifold that link onto the air induction tubes but there is no mechanism or linkage to control the tubes from outside the air intake manifold. are the induction tubes not used on carburetor conversions? if not used should they be open or closed all the time? if something controls them in a 6 port carburetor conversion then what is it? |
Im guessing youre talking about the 6 port induction sleeves, typically no they are not used. You have a picture of the setup, so we have more of an idea what is going on with your car?
|
Originally Posted by SpikeDerailed
(Post 12263780)
Im guessing youre talking about the 6 port induction sleeves, typically no they are not used. You have a picture of the setup, so we have more of an idea what is going on with your car?
https://www.rx7club.com/g/album/9421274 |
What did you do on this. I have an 87 na that I am try to switch to carb set-up too. Not sure what to do with those.
|
Originally Posted by 007bolt
(Post 12267258)
What did you do on this. I have an 87 na that I am try to switch to carb set-up too. Not sure what to do with those.
so leaving them open would require more fuel but it would get more air and power. still never got an answer though |
Originally Posted by 007bolt
(Post 12267258)
What did you do on this. I have an 87 na that I am try to switch to carb set-up too. Not sure what to do with those.
|
All times are GMT -5. The time now is 07:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands