RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   wont turn over (https://www.rx7club.com/1st-generation-specific-1979-1985-18/wont-turn-over-436992/)

txredneckmedic 06-24-05 01:15 AM

wont turn over
 
Well I picked up my 84 rx7 today, put alot of MMO into it, turned it by hand...put more....got it turning real nice. But now the starter isnt starting...hehe. If its the relay can I just bypass it and put it on a push button? Also....how do you get the rear ignitor off?? well mines like on the side....by the alternator and cant get it out. and the screws almost stripped now

Rotor13B 06-24-05 01:22 AM


Originally Posted by txredneckmedic
Well I picked up my 84 rx7 today, put alot of MMO into it, turned it by hand...put more....got it turning real nice. But now the starter isnt starting...hehe. If its the relay can I just bypass it and put it on a push button? Also....how do you get the rear ignitor off?? well mines like on the side....by the alternator and cant get it out. and the screws almost stripped now

Heh, You have to pull the distributor to get the backside ignitor off. Why do you need to remove it anyways?

txredneckmedic 06-24-05 01:33 AM

I wanna try something....the guy i bought it from said the fuel pump wasnt working...and from what i understand....the rear ignitor controls the fuel pump also

RRTEC 06-24-05 01:39 AM

NO.. well wait.. I don't know about the GSL_SE buut the 12A'd cars the fuel pump runs constantly while the key is on, it has ABsolutely nothing to do with the igniters.

txredneckmedic 06-24-05 01:42 AM

well i can tell ya that the fuel pump aint working now. My main concern though is the starter

Rotor13B 06-24-05 04:12 AM

I can't believe I forgot to say this, Make sure the signal wire is hooked up to the starter also. It's a small wire with spade connector on it. This is a common reason why starters "go out". I had this happen once where I drove through a grassy feild/parking lot and the underbrush knocked the wire off my starter. Since my car was running obviously I didn't notice till the next day when I tried to go to work. Got in turned the ignition, Nothing. Hmmm, Check fuses and there ok, Battery was fine as everything else worked so I think starters out. I jacked up my car to pull the starter off when I noticed this little wire hanging and almost at the same time saw a small connection on the starter. Plugged it back in presto, No more problem!!!:)

Siraniko 06-24-05 07:17 AM


Originally Posted by Rotor13B
Heh, You have to pull the distributor to get the backside ignitor off.


why? just move the alternator out of the way OR use a ziggy screw driver.

txredneckmedic 06-24-05 04:03 PM

Well I got her running...it was the starter....now all i gotta do is put in a new fuel pump, drain the gas tank and fill her up....oh and get new tires :bigthumb:

Rotor13B 06-24-05 04:11 PM


Originally Posted by wackyracer
why? just move the alternator out of the way OR use a ziggy screw driver.

I've done both and it's just easier to pull the distributor after marking it of course.:)

spiderman833 06-30-05 07:46 PM

I just got an 84' gsl-se working on swapping the engine into a 83 b/c the body is better on it. ANYWAY. the car ran decent when I picked it up but now all I can hear is a humming when I try to start it. not turning over at all. brand new battery and fully charged. any idea's??

txredneckmedic 06-30-05 09:12 PM

pull the starter and take it to your local parts store to have them check it

spiderman833 07-01-05 08:30 AM

how would I get to that? I tried following the POS wire from the batter. that's it right? but it slowly dissappears to the bottom of the engine compartment.


All times are GMT -5. The time now is 03:40 AM.


© 2024 MH Sub I, LLC dba Internet Brands