RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   sputtered and died...wont start back up (https://www.rx7club.com/1st-generation-specific-1979-1985-18/sputtered-died-wont-start-back-up-689233/)

Rotor_king 09-17-07 03:46 PM

sputtered and died...wont start back up
 
My dad and i had just completed an engine swap 12a to 12a and the car started perfectly. I drove it the whole weekend with no problem, until sunday night. I had just dropped off a friend, and as i was pulling up to a stop light the car sputtered and died. I tried to start it and it would just crank over and over again. It seems like its cranking over faster than before, and im in fear of bad seals. Any suggestions to this problem would be very helpful.
thanks.

Rotor_king 09-17-07 03:46 PM

its an sa by the way

Kentetsu 09-17-07 03:50 PM

Check for spark, check for fuel to the carb. Then post back with results...

Rx-7Doctor 09-17-07 04:36 PM

Check to make sure their is fuel in the tank. :-)

And of course that the fuel pump fuse did not blow.

Rotor_king 09-17-07 04:44 PM

ive got gas and the fuel pump works. But i just went out and it started... roughly. When i would step on the gas and let off it would hold the rpms i went to for around 3 seconds, then go back to idle. I switched it off and then it wouldnt start up again...still need to check for spark.

trochoid 09-17-07 05:51 PM

Sounds like you may have flooded the engine. The no start and fast spinning starter is an indication of that.

Rotor_king 09-17-07 09:28 PM

yeah i have the mix screw as lean as possible and it still backfires and is running far too rich...guess its time to rebuild the carb. : (


All times are GMT -5. The time now is 09:26 AM.


© 2024 MH Sub I, LLC dba Internet Brands