Replacement Fuel Pump Question
 

I need to replace my stock fuel pump. I would like to know the best one to get without needing a regulator. If only the stock fuel pump can do that then please let me know. My setup includes a Sterling Nikki with economy jets, stock exhaust, Accel square coils and K&N air filter.

Thanks for the help.

the stock pump may be sufficient.

Thanks for the help

correct....it may be.

If I recall correctly, Sterling recommends around 3 +/- psi for his carb. I don't have mine hooked up yet, so I can't tell you what I am running this week.

I just checked the FSM, and the factory fuel pump puts out 2.84 - 3.54 psi, found on page 16 of chapter 4A out of the 1985 Fuel and Emissions chapter of the Factory service manual which can be downloaded here (which I HIGHLY recommend you do!) - http://foxed.ca/foxed/index.php?page=rx7manual#firstgen

The factory specs of the fuel pump are good for the sterling when new, but after years of wear and tear it can reduce the pressure;

Many people on the boards say that when they upgraded their fuel pump to something else, with a regulator, they had much more power as they weren't starving the engine from fuel when they got on it hard. This is something you may have to deal with.

A regulator is $40 or so shipped from summitracing.com; I would highly recommend saving up and getting a higher pressure fuel pump with a regulator. Or (shameless plug), you can buy my Holley/Summit Racing fuel pump WITH a regulator and wiring kit for $80 plus shipping :P

What has been proven to work: https://www.rx7club.com//showthread.php?t=529605





.

that's what im running. +1 for this setup

+1 works amazing

Thanks everyone.... I installed a fuel pump