Removed ACV and now idles low....
 

I removed the air pump and converted to RB presilencer a month ago and now just got around to buying a ACV block off plate. Take off the ACV and slap on the plate. After warms up idles low around 450 RPM instead of my normal smooth 800 RPM. Am I supposed to complete the electrical circuit that WAS there and is now just a haning connector that used to go to the ACV??? There wasn't any vaccum lines going directly to the ACV but to the plate in the intake. What am I supposed to do? I heard RB makes a writeup on removing the air pump and ACV with header installation. I got my header used, no paper. Please help ASAP. Thanks!!!!!!!!

Vacuum leak around the plate?

bump^^

did you use some gasket maker on your new plate..........the you may have not pluged the 5/32" nipple that comes out just above where the acv was

can someone shoot a pic and show me where this plate is supposed to be. I have to clue as to what the p.o. did to my car before I got it. But Mine Idles at about 300 also. I'm going to adjust the carb but wanna check this plate first and the hose blockoff.

like this but note one of my nuts is broken, but thats a different story :(

could be that broken nut. if one side is being torqued down then it is possible for it to be leaking.

That's not a pic of the thread starter's plate, that's someone answering a request for a pic of the ACV block-off plate.

YO!! YO!! YO!! Blazer your ACV Gasket is on its way you should see it tomarrow in the mail..

Later
Dan Atkins

thanks Dan!!!

wouldnt that cause HIGH idle??

I'd say not, seeing as he's ordered an ACV gasket, presumably for the block-off plate (why not RTV?).

I can't say for certain one way or the other, but if the guy says he can't get an idle right after blocking off the ACV the first question is, "Did you use gasket material?".

Nope...just the plate...:D