RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   My car won't go (https://www.rx7club.com/1st-generation-specific-1979-1985-18/my-car-wont-go-683461/)

RX7wieler 08-27-07 05:41 PM

My car won't go
 
so yesterday I was driving around and I raced my friend (and won) and when I went to put it in 5th it ground badly. So i put it in 4th and drove through the 80kmph zone and tried 5th again but still no go so i got mad :mad: and slamed it in to 5th and something broke. Now when i push in the clutch there is no feeling it is just air. i can put it in to any gear with out the clutch and if thats not bad enough it doesn't drive.:crying: It starts without the clutch also.

Kentetsu 08-27-07 06:44 PM

Sounds like you broke her... :(

Might not be anything really serious though, so don't give up hope. Can't think of what it might be right off the bat, maybe the clutch fork? Slave cylinder? Are you leaking any clutch fluid, or is the resevior empty? Sounds like you might be pulling the tranny to deal with a clutch issue...

RX7wieler 08-27-07 06:51 PM

when i push in the clutch the slave cylinder still works and there are no leaks. Did i brake the clutch or my gears or what?

P_Lav 08-27-07 06:53 PM

You probably blew your pressure plate, but maybe, just maybe you only wrecked your throwout bearing.

83rx7boy92 08-27-07 09:12 PM

just pull the tranny and check it out....dosent take long...i pulled mine and it took longer to get the exhaust shielding off then it did to take the tranny out


All times are GMT -5. The time now is 05:00 AM.


© 2024 MH Sub I, LLC dba Internet Brands