RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   85 gsl-se need help (https://www.rx7club.com/1st-generation-specific-1979-1985-18/85-gsl-se-need-help-1027082/)

rx78581 02-21-13 04:07 PM

85 gsl-se need help
 
Hey everyone i have a 85 gsl-se that i am have problems with i picked this car up for 350$ picked it up for a donor car the car sat for 2 years i got the car home started going through it found rotted fuel lines and fuel filter so i fixed those just to try to get it running i got to fire up and run now here is the problem as long as i keep my foot on throttle even the tiniest bit it will stay running but will not idle at all if i didnt give enough info just ask but any help would be great thanks guys

andernamen 02-21-13 04:31 PM

I just went through this with my 1985 GSL-SE that sat for 5 years. Basically, you will have to go through the entire fuel system, tank to injectors. Pull the drain plug and then drop the tank. Make sure there are no holes anywhere. Remove the tank internal suction line and clean the plastic screen. Put degreaser in the tank and let it sit for a while. You may just want to consider taking the tank somewhere and having it boiled and coated. Once the tank is clean with no rust, put it all back together but first check both the metal suction and return lines. Run something thru them to ensure there is no crud inside. Pull the fuel pump and filter. Replace the filter with a new one. Blow out all your lines (toward the rear). Hook the pump up to 12volts to make sure it is working. Pull your injectors and at a minimum clean/check the metal screen and consider sending them off to be cleaned and flow tested. You shouldn't have any more problems if you go through all of this. PIA I know, but worth it.

Rotary-MG 02-21-13 04:43 PM

If you set the idle higher will it stay running?
What is the minimum RPM that you can maintain?
How smooth is the engine as you climb up in RPMs?
What color smoke coming out of the tail pipe, if any?
Did you drain the fuel tank?
What are your plans with the donor?
What components are you planning of pulling, and what are they going into?
What color is the sky in Chernobyl?
If I spit on a kumquat does that make me a lesbian?
Was the PO a democrat or republican?
Did you do an Ohm test on your TPS?
What was I going to ask you next?
Do you have direct fire?
Have you done a compression test?
Paper or plasitc?
Wait, what's your question???

There are so many questions we could be asking (many irrelevant), but wouldn't it be easier on us if you could tell us more? Shouldn't we be answering question than asking?

I had a donar '84 GSLSE that I bought cheap, stripped and then sold. The PO couldn't get it to run properly, but after a new TPS, it ran like a champ. But that was my situation, not yours.

rx78581 02-21-13 04:43 PM

Thanks for the advice i have a new mazda fuel pump that i was going to put in but i am glad i didnt now would been a waste untill i do the rest of this stuff first do u have any suggestions on shops that clean and flow check injectors

dabranco 02-21-13 04:55 PM

Are you in peoria az, or peoria IL, I know of a couple of shops in peoria Il I can direct you towards

rx78581 02-21-13 04:56 PM

I didnt drain the tank stupid me
As soon as i let my foot off the throttle it idles down then stalls
I have not ohmed the tps
It is a completely stock motor
have not adjusted high idle

rx78581 02-21-13 04:57 PM


Originally Posted by dabranco (Post 11383641)
Are you in peoria az, or peoria IL, I know of a couple of shops in peoria Il I can direct you towards

I am in peoria il

rx78581 02-21-13 05:02 PM

I am taking the full drivetrain and engine out and putting it in my 85 gs the gsl-se is completely rusted out from floor boards to inner fender wells

dabranco 02-21-13 05:03 PM


Originally Posted by rx78581 (Post 11383643)
I didnt drain the tank stupid me
As soon as i let my foot off the throttle it idles down then stalls
I have not ohmed the tps
It is a completely stock motor
have not adjusted high idle

OK let start with the basics, drain the tank, put in fresh gas and some seafoam,
Have you checked your plugs and wires? If not maybe time to do a tune up. Do these first also do you have a chilton manual?

rx78581 02-21-13 05:07 PM

The plugs looked good and wires were ohmed out and were fine i will pull the tank tonight and clean it and go from there thanks it has been to long away from the rx's

dabranco 02-21-13 05:07 PM

What are you doing with the engine from the GS?

dabranco 02-21-13 05:08 PM


Originally Posted by rx78581 (Post 11383659)
The plugs looked good and wires were ohmed out and were fine i will pull the tank tonight and clean it and go from there thanks it has been to long away from the rx's

I know man I was gone almost 10 years relearning this stuff sucks, but it is fun.

rx78581 02-21-13 05:09 PM

I blew the apex seals in it 9 years ago been in a garage ever since

rx78581 02-21-13 05:12 PM


Originally Posted by rx78581 (Post 11383644)

I am in peoria il

What shops in peoria il i was not aware of any

dabranco 02-21-13 05:13 PM


Originally Posted by rx78581 (Post 11383662)
I blew the apex seals in it 9 years ago been in a garage ever since

ill take it shoot me a price.

rx78581 02-21-13 05:13 PM

Where r u located at

dabranco 02-21-13 05:15 PM

Ohlly's radiator repair, he is busy but one of the best if not the best took about a month to resael my spare fuel tank.
And rex radiator and welding. or I can trade you my spare tank for something....

dabranco 02-21-13 05:16 PM


Originally Posted by rx78581 (Post 11383669)
Where r u located at

East Peoria Il right across the river.

rx78581 02-21-13 05:16 PM

I have no idea

dabranco 02-21-13 05:46 PM

PM sent

rx78581 02-21-13 05:55 PM

Pm sent


All times are GMT -5. The time now is 08:02 AM.


© 2024 MH Sub I, LLC dba Internet Brands