RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   1st Generation Specific (1979-1985) (https://www.rx7club.com/1st-generation-specific-1979-1985-18/)
-   -   12a streetport (https://www.rx7club.com/1st-generation-specific-1979-1985-18/12a-streetport-1131517/)

rx7junkie170 11-12-18 01:55 PM

12a streetport
 
When I was installing my engine I noticed that my stock intake was ported while I was changing my air filter I noticed that my jets where 140s for mains and idk about the secondaries what do ya decordmend I was told 160 main 180 175 secondaries

t_g_farrell 11-12-18 06:34 PM

What carb?

rx7junkie170 11-13-18 02:28 AM

Stock Nikki with stock ported manifold

t_g_farrell 11-13-18 07:52 AM

I have a stock port 12A with a modded nikki and I think my primaries are 105 and the secondaries are 160 but I would have to double check that.

What jets are you looking at? The fuel jets can't be seen unless the top is off the nikki cause they sit at the bottom of the fuel bowl under gas.Did you have the top off the carb then?

Jeff20B 11-13-18 10:40 AM

Jet sizes are sized according to how large your venturis are and your air bleeds. In other words they tie into how much air is entering your engine and how the engine responds to it. If you just swap in bigger jets and change nothing else, you are just going to go pig-rich which wastes gas and makes you slower.


All times are GMT -5. The time now is 05:31 PM.


© 2024 MH Sub I, LLC dba Internet Brands