RE swapped, Airwerks S200-7670, pump gas, Adaptronic E420D
#1
RE swapped, Airwerks S200-7670, pump gas, Adaptronic E420D
Stock unopened 13REW Jspec with good compression. Still has those OEM restrictive RE exhaust sleeves too!
I will have to look at the ECU file, but I cannot remember if this car had the IGN-1A coils or just OEM.
It was on pump gas @ 8 psi, .91 T4 s200 7670(56mm compressor inducer), 3" exhaust, HKS cast with open WG, Adaptronic E420D wire in model, small filter/TID...
Also made 411rwhp @ 18psi @ 6k rpms, but I shut it down as the owner did not want that kind of power. It would have been 440/450rwhp by redline. Not bad
I will have to look at the ECU file, but I cannot remember if this car had the IGN-1A coils or just OEM.
It was on pump gas @ 8 psi, .91 T4 s200 7670(56mm compressor inducer), 3" exhaust, HKS cast with open WG, Adaptronic E420D wire in model, small filter/TID...
Also made 411rwhp @ 18psi @ 6k rpms, but I shut it down as the owner did not want that kind of power. It would have been 440/450rwhp by redline. Not bad
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM