SirCygnus

iTrader: (1)

im using ms pcb v3

well, i was rechecking everything over and over again on my megasquirt, and then it struck me, there is no clear and precise way to wire up this dang thing ( vr circuit mainly ).

my main headache is how to properly wire it up. i use half of this,


but this piucture doesnt how me jack didly how to wire up the single vr sensor by itself. so then i used this one



which muay thai told me was uuber doodoo so i kind of combined them both. then i was looking over this picture




and i saw that i also needed a 1k resistor from vr2 out to js8. howcome in my many searches that the 1k resistor never ever showed up?

is this not needed? how badly do i need this? also, could someone please alter the first picture with the dual vr circuit so that i can read it? and no, cutting the picture in half tells me something different than the first picture.

SirCygnus

iTrader: (1)

well after looking through the logs on gaim from my conversations, it seems he said it. but i guess it was realy realy late (2 am) and i simply forgot. i dont know. it was very very frustrating because i didnt understand anything and there is information scattered all over the pace that i didnt know what i was supposed to do. i guess ill run out to radiocrap tomarrow

KrisGXL

I'm not quite sure what your asking but if it helps here is a pic of the single vr conditioner that I am using in my car right now with good success.

B.T.W. I think the 1K resistor is just for protection, but someone correct me if I'm wrong on this.

SirCygnus

iTrader: (1)

see, in this one it does show a stinking 1k. the others there is no mention of it.

SirCygnus

iTrader: (1)

ok since i cant edit my posts, where does the .1 uf cap go?

muythaibxr

There isn't a .1 uf cap if you look at the diagrams that are in the FAQ.

KrisGXL

I edited that diagram to show the circuit that I am using right now