Haltech datalogging units
#1
datalogging units
last night i was datalogging e6x (first time logging with x) tuning a friend's car and i noticed the units for the MAP log is in an unknown unit. i'm guessing its kilopascals (kPa), but i'm not for sure. is there any way to change the units to imperial for the datalogging in e6x? this is the halwin software btw.
thanks!
thanks!
#2
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
Originally Posted by jacobcartmill
last night i was datalogging e6x (first time logging with x) tuning a friend's car and i noticed the units for the MAP log is in an unknown unit. i'm guessing its kilopascals (kPa), but i'm not for sure. is there any way to change the units to imperial for the datalogging in e6x? this is the halwin software btw.
thanks!
thanks!
1PSI = 6.89Kpa...
The same applies to the O2 sensor input, with the X you can only view millivolts, there is a formula to change it to AFR. But the formula for this will depend on the sensor/controller you use.
Last edited by Claudio RX-7; 09-18-06 at 12:29 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM