RX7Club.com - Mazda RX7 Forum

 
Page 1 of 20
1
2
3
4
5
11
Last »
Search: Posts Made By: HAILERS
Showing results 1 to 25 of 499
Search took 0.37 seconds.
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 08:45 PM
Replies: 27
Views: 3,780
Posted By HAILERS

**************************************************...

*********************************************************************************************************************************************************

This is a good example of how the stk...
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 08:29 PM
Replies: 21
Views: 1,947
Posted By HAILERS

That relay must still be functional 'cause you...

That relay must still be functional 'cause you say you turned the engine over with the starter. That relays intermal contacts pass the Start power from the key to the starter solenoid, so obviously...
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 08:19 PM
Replies: 1
Views: 2,165
Posted By HAILERS

I truly don't have much of a clue other than the...

I truly don't have much of a clue other than the jpg attached that came out of the MANUAL TRANSMISSION section of the FSM. It SEEMS the flat is on the left side of the transmission.

Like I say, I...
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 08:03 PM
Replies: 5
Views: 765
Posted By HAILERS

Sorry to say, but I looked very closely at my...

Sorry to say, but I looked very closely at my cars for hours today, and nowhere did I find the RED X device. Sorry 'bout that.
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 12:28 PM
Replies: 27
Views: 3,780
Posted By HAILERS

Split air would go continuouly to the converter....

Split air would go continuouly to the converter. There's not much *METERING* involved in this at all. The AMOUNT of air from the Split Air Solenoid is NOT anywhere close to the ACV SWITCHING to full...
Forum: 2nd Generation Specific (1986-1992)
Aug 1, 2010, 10:27 AM
Replies: 29
Views: 2,281
Posted By HAILERS

SILERROTOR.............What are the colors of the...

SILERROTOR.............What are the colors of the two wires in the plug on the left of your picture. The two wire plug that has foam on it?
Forum: Rtek Forum
Jul 31, 2010, 07:54 PM
Replies: 38
Views: 5,414
Posted By HAILERS

The idea here is that the brown/red ouput wire of...

The idea here is that the brown/red ouput wire of the sensor is also spliced to another wire that goes to the boost gauge in a turboII car, so one wonders if that wire has some voltage on it that is...
Forum: 2nd Generation Specific (1986-1992)
Jul 31, 2010, 07:51 PM
Replies: 29
Views: 2,281
Posted By HAILERS

If the plug on the left of the picture has two...

If the plug on the left of the picture has two wires, and one wire is L/W and the other L/Y, then that plug is for a speaker on the drivers side to the left of the steering column and near the door....
Forum: Rtek Forum
Jul 31, 2010, 06:01 PM
Replies: 38
Views: 5,414
Posted By HAILERS

What do they read prior to pulling a vacuum on...

What do they read prior to pulling a vacuum on them? Seems that would settle things a bit. They're supposed to read two something volts with no vacuum on 'em. See CONTROL UNIT in the Fuel and...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:57 PM
Replies: 25
Views: 2,968
Posted By HAILERS

When I got my RTEK(s) the car would start up just...

When I got my RTEK(s) the car would start up just fine without anything else being done. As in Palm not connected etc. Must be another thing.

Lack of fuel but??? why? Got fuel for a start but car...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:51 PM
Replies: 25
Views: 2,968
Posted By HAILERS

See jpg attached. I'd have only one wire in...

See jpg attached.

I'd have only one wire in those jpg working. That would be the START signal to the ECU and nothing else. And that only having pwer when the key is HELD to STart.

The BR that...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:31 PM
Replies: 25
Views: 2,968
Posted By HAILERS

No fault codes on the RTEK??? And...

No fault codes on the RTEK???

And ps..........the afm volage on 2B should start out high and work its way down. Like start out at 4 volts and as the cone is pushed aft go to one or maybe less. If...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:23 PM
Replies: 25
Views: 2,968
Posted By HAILERS

Oh. Series five worry me 'cause I don't have one...

Oh. Series five worry me 'cause I don't have one and their afm signal is a bit different. It has no switch inside it like the series four to keep the pump a runing. I THINK it uses the signal from...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:20 PM
Replies: 25
Views: 2,968
Posted By HAILERS

I would not have the ECU see batt voltage all the...

I would not have the ECU see batt voltage all the time. Only when the key is HELD to START.

I've never actually wired 3B with constant batt voltage all the time when key is ON, so I can't say that...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:09 PM
Replies: 25
Views: 2,968
Posted By HAILERS

Well when the ECU sees the START signal it uses...

Well when the ECU sees the START signal it uses the internal START fuel map..................until the engine actually start and gets over 500 rpm whereupon the start fuel map isn't used anymore and...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 01:00 PM
Replies: 15
Views: 9,759
Posted By HAILERS

**************************************************...

***************************************************************************

ON the back.........on a series four TurboII that has four nipples, only ONE is vacuum and that is the very bottom one....
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 12:52 PM
Replies: 25
Views: 2,968
Posted By HAILERS

No, what is happening is you go to START. That...

No, what is happening is you go to START. That START signal puts power on ONE of the TWO coils in the Circuit Opening Relay which in turn feeds the fuel pump. Car starts.

You let the key go from...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 12:42 PM
Replies: 4
Views: 870
Posted By HAILERS

If you'll probe the output Voltage of the AFM to...

If you'll probe the output Voltage of the AFM to the ECU, you'll find the voltage changes more or less in a liner fashion. Like starts at 1vdc and works it's way up to the max potential which would...
Forum: 2nd Generation Specific (1986-1992)
Jul 30, 2010, 12:24 PM
Replies: 9
Views: 798
Posted By HAILERS

Are you aware that any RX whos rpm go over approx...

Are you aware that any RX whos rpm go over approx 1100-1200 rpm.............the ECU will advance the timing and make the idle not sound/be good. But then again 1100-1200 is not an idle speed. When...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 05:26 PM
Replies: 15
Views: 9,759
Posted By HAILERS

Well I owe everybody an apology. On the front the...

Well I owe everybody an apology. On the front the top one is vacuuum..........second one is air (no suction when at idle) and the third is vacuum.

I put pieces of PVC pipe on the turbo car in...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 04:25 PM
Replies: 15
Views: 9,759
Posted By HAILERS

Yes. I KNOW the rear is like that and the front...

Yes. I KNOW the rear is like that and the front should be as you just listed. I think I'll just go out and put a piece of PVC on my truboII and make sure about the front.

On a series four NON...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 04:22 PM
Replies: 17
Views: 2,385
Posted By HAILERS

Remember, I said I'd never done this to a series...

Remember, I said I'd never done this to a series five myself, but the last link shows how to make a checker out of two LED's from radio shack. Cost is very, very small.

So if it works, then look...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 01:52 PM
Replies: 17
Views: 2,385
Posted By HAILERS

In the area of your LEAD coil assy there is a...

In the area of your LEAD coil assy there is a GREEN six scoket elect plug called a Check Connector and it's used for downloading fault codes.

It has three wires. One wire is black/white and if you...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 01:20 PM
Replies: 15
Views: 9,759
Posted By HAILERS

The rear of the jpg of your is correct. Only the...

The rear of the jpg of your is correct. Only the bottom nipple is vacuum, the others are metered air (not vacuum is metered air).

On the front the top nipple is vacuum as shown in the attached...
Forum: 2nd Generation Specific (1986-1992)
Jul 29, 2010, 01:03 PM
Replies: 4
Views: 759
Posted By HAILERS

Hitting a large puddle would not effect most of...

Hitting a large puddle would not effect most of the items powered by the Meter fuse. BUT there is that REVERSE switch under the car and attached to the transmission. THAT might have shorted out for...
Showing results 1 to 25 of 499
 
Page 1 of 20
1
2
3
4
5
11
Last »


 
Forum Jump


All times are GMT -5. The time now is 08:46 AM.