(1) Dataq DL-194RS Driver Box/Software - $24.95
http://www.dataq.com/products/startkit/di194rs.htm

(2) Measurement Specialties, Inc. Pressure Transducer - $124
MSP-300-250-P-4-N-1, 0-250 psi, 0-5 volts
http://www.mouser.com/msi/

(3) Quick Disconnect Plug Adapter
Two of the connectors are from any store selling air hose connectors,
cost about $5. The 14mm plug adapter is from a cheap mechanical tester
which cost about $30.

(4) Battery Pack (optional) - about $3 without 8 batteries.
From an electronics store. The pressure transducer needs between
10 - 30 vdc to run. My small car battery voltage drops to about 9vdc when
cranking. Thus I made this small 12vdc battery pack to insure a stable power
supply.

Minor Parts

(1) Serial to serial port connector

(2) Battery to DATAQ connector

(3) Wire to lengthen transducer cable

(4) Tie Wraps to secure wiring.

Hey Im looking for some help on my Fc i did a xcomplete T2 swap and i mean completly everything even the column and the bitch wont start i cant find outwtf is wronf with it. Im willing to pay for your hand in finding the problem.

dude, do you go to freedom wash with jan and them? also, do you happen to go to odu?