Adaptronic Cranking fuel table messed up?
#1
Full Member
Thread Starter
Cranking fuel table messed up?
ok, so firstly the car is running great, and when its cold it will start up with no problem, but when its at temp and i try to start it it will just keep cranking till it cuts then wile its cutting i get a little sputter of life befor it dies again and repeats the cycle.
i have tried messing with the cranking fuel numbers up and down from 30 up to 200 and none of them seem to catch, is there somewhere else or something else i should be doing to get it to catch?
note* it does start if i feather the throttle in and out a bit as i crank. and runs perfectly fine elsewise
i have tried messing with the cranking fuel numbers up and down from 30 up to 200 and none of them seem to catch, is there somewhere else or something else i should be doing to get it to catch?
note* it does start if i feather the throttle in and out a bit as i crank. and runs perfectly fine elsewise
#4
Full Member
Join Date: Sep 2013
Location: Philippines
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
Hi Sherff,
Can you please email us a log of your no-start condition + a copy of your current ECU file to tech@adaptronic.com.au?
Thanks!
Can you please email us a log of your no-start condition + a copy of your current ECU file to tech@adaptronic.com.au?
Thanks!
#5
Full Member
Thread Starter
Yup, will do, just to say it again it starts with absolutely no hesitation on like the second crank when cold, just when warm I have to feather the throttle a lil bit to get it to catch
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM