3 hard fuel lines on the drivers side of the engine bay
#1
Eats, Sleeps, Dreams Rotary
Thread Starter
3 hard fuel lines on the drivers side of the engine bay
that connect to the hard lines under the UIM.
When I took my rats nest out and installed the fuel pressure sensor, I labeled the lines with tape but they have since fallen off.
I can't remember which line goes where. The FSM isn't that clear either.
Anyone help with this simple question? If you have the engine rebuild video, that should have it there.
Thanks a bunch.
When I took my rats nest out and installed the fuel pressure sensor, I labeled the lines with tape but they have since fallen off.
I can't remember which line goes where. The FSM isn't that clear either.
Anyone help with this simple question? If you have the engine rebuild video, that should have it there.
Thanks a bunch.
#3
Eats, Sleeps, Dreams Rotary
Thread Starter
Bacon,
thanks. Then the hard lines under the UIM the left is feed, right is return and the top is the charcoal (standing on the drivers fender looking at the UIM) correct?
thanks. Then the hard lines under the UIM the left is feed, right is return and the top is the charcoal (standing on the drivers fender looking at the UIM) correct?
#4
Eats, Sleeps, Dreams Rotary
Thread Starter
Still having a bit of a problem and need a little clarification of these lines heading to the fuel rails
The top one is from the charcoal cannister, the lower left one is the feed, the lower right one the return. Correct?
The top one is from the charcoal cannister, the lower left one is the feed, the lower right one the return. Correct?
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM