Wideband O2 output voltage
 

I picked up an AEM Digital Wideband Air / Fuel Gauge 30-4100.

Nice unit, works really well. However, the output to "any" engine management system isn't consistent with the old O2 sensor output.

On page 9 of the manual here: http://forum.aempower.com/forum/inde....0;attach=4370, it indicates there are different modes to configure the unit with for output voltages.

Anyone know what the proper output setting should be for the Wolf 3D v3? Right now, all my numbers on the wolf are way off.

I'm guessing I need to set it to P2 - but would love to confirm if anyone knows the answer straight away...

Dave

Answering my own question - turns out the Wolf shows stoich at a value of 4 or 5, not 7 as I had incorrectly remembered.

So, it looks like the AEM WB output is correct. On with more tuning.