Look over my map
 

This is from a car I just bought. The car has cold start issues, but only if it has sat for a while (overnight). On the controller I can see the RPM spike to 53000something during cranking, then back to 0, to 200rpm and just bounces between 0 and 2000 until it finally starts with some pedal effort.

I've never used a Wolf before, so I don't know all the perticulars of the setup. The cas has all of the original teeth and the wiring looks ok with a quick glance.

If there are any obvious problems in the map let me know, I haven't looked through it completely yet.

S5 T2 running a V4 ecu

Streetport, BNR Stage 4 running on wastegate pressure, stock IC for now, stock primaries ( i think), 1600cc secondaries, running on Cali 91 with premix.

Thanks for any help you guys can give!

Mate, I would hold off driving this - especially under boosted conditions.

This map is setup for NA - not turbo. Have a look in the PC Software with the map loaded under "Configuration --> Sensor Setup --> Load" & then "Internal Sensor PSI"

The fuel map doesn't look good either.

I'd try running one of the maps from Michael Smith's site ( http://www.angelfire.com/droid/wolf3dems/ )

ie, this map http://www.angelfire.com/droid/wolf3...cdecayflat.wmf

Should be a good base to tune from.

Note that this map is set for a Wolf3D V3 modified CAS. If you choose to run this map you will need to change the ignition configuration settings to suit the std mazda cas.