Recent dyno pull
 

Hey guys, did a recent couple pulls at a local place with mustang dyno. Was hoping for a bit more to be honest.

FD RX7 Mustang Dyno pull - YouTube

282RWHP
280Torque

My current list of mods:
13B Streetport
Apexi Power Fc with commander and Datalogit.
Blitz FMIC
HKS Wastegate
Greddy Blow off valve
Glowshift Wideband
Glowshift Boost Gauge.
Blitz Twin SBC Electronic Boost controller
Denso Supra Fuel Pump
850/850 Prim/Sec Injectors
B&M New Volt Ignition Amplifier
Oil pan reinforcement brace.
Borg Warner/s300 Hybrid 66mm Single Turbo
AEM Water/Meth kit
3.5" front to back exhaust all emissions removed.
19psi
Car is always driven with 94 Octane

If anyone is good with power fc tuning, IGT/IGL maybe can take a look at the settings gimme some suggestions?

If anyone is good with power fc tuning, IGT/IGL maybe can take a look at the settings gimme some suggestions?
Yes. See Brian Davies "Wargasm" on rx7club.com detailed, excellent, step by step tuning of his FD3S-1993 & later RX-7 article.
"Single Turbo RX-7s and the Power FC"
Abstract: This document is meant to explain some of the basic concepts and methods used to tune a single turbo 1993+ Mazda RX-7 using the Apexi Power FC in combination with the Datalogit interface box, a laptop computer, and a wideband oxygen sensor. Good luck if you are still in it!