Need help with removal of front rotors
1 Attachment(s)
Short version:
I am attempting to replace my stock rotors with brembo drilled a slotteds. After seeveral hours of carefully trying to remove the 2 screws holding the rotor in I finally stripped the heads. So I decided to drill the screws out. I had no problem doing this(See picture). I then proceeded to use a bolt to pop the rotor off. And the head of the bolt breaks off, and ofcoarse I cant get it out(see picture). I have no I dea what keeping the rotor on. I have soaked it with WD40(it has been soaking since last night, Soaked it again today too). I have been trying to nudge it off with a hammer, but don't want to hit it too hard. I'm out of Ideas. I just soaked it down again with WD40 before coming to type up the post. Hoping I will hear the rotor crashing to the garage floor any minute now. But just in case it doesnt, anyone have any suggestions. |
You are gonna have to give a couple of good whacks.
I had to suck it up and grab a rubber mallet and beat it. It popped off after I "talked" to it |
Ha... good luck bud. My front rotors were siezed onto the hub , I had to take the whole front hub assembly off and use a hammer to break the stock rotors off in pieces. Heres a pic of the aftermath :
https://www.rx7club.com/attachment.p...chmentid=68932 Me-1 Rotor -0 |
Went wedieval with the hammer came off after about 10 minutes of pounding I was about the take the hub assembly off too. Well Time for the other side :( .
|
The other side wont budge. Any suggestions.
|
I've found that PB Blaster works a lot better than WD-40. Buy a can of that and see if it works better for you, it only costs about $3 per can.
|
If the rotors are so stuck that they won't even come off when using the provided bolt hole try heating the hat area around the studs with a torch. Get the entire center section very hot and then try threading the bolt in. I bet they come off then.
|
well, the rotor stock has an extra screw hole to use one of the screw you drilled out, ...you insert it, hit it a fewt times with the impact whrech and there ya go :)
That worked for all but my rear right rotor, which i took a sledge to :) |
1 Attachment(s)
This is the mo fu#!ng man. Was using a regular hammer before.
https://www.rx7club.com/attachment.p...id=96223&stc=1 Im all done with my brakes :) |
All times are GMT -5. The time now is 09:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands