Need help with removal of front rotors
#1
#1 F0RUM TROLL
Thread Starter
Join Date: Mar 2002
Location: Naugatuck, CT
Posts: 1,132
Likes: 0
Received 0 Likes
on
0 Posts
Need help with removal of front rotors
Short version:
I am attempting to replace my stock rotors with brembo drilled a slotteds. After seeveral hours of carefully trying to remove the 2 screws holding the rotor in I finally stripped the heads. So I decided to drill the screws out. I had no problem doing this(See picture). I then proceeded to use a bolt to pop the rotor off. And the head of the bolt breaks off, and ofcoarse I cant get it out(see picture).
I have no I dea what keeping the rotor on. I have soaked it with WD40(it has been soaking since last night, Soaked it again today too). I have been trying to nudge it off with a hammer, but don't want to hit it too hard.
I'm out of Ideas. I just soaked it down again with WD40 before coming to type up the post. Hoping I will hear the rotor crashing to the garage floor any minute now. But just in case it doesnt, anyone have any suggestions.
I am attempting to replace my stock rotors with brembo drilled a slotteds. After seeveral hours of carefully trying to remove the 2 screws holding the rotor in I finally stripped the heads. So I decided to drill the screws out. I had no problem doing this(See picture). I then proceeded to use a bolt to pop the rotor off. And the head of the bolt breaks off, and ofcoarse I cant get it out(see picture).
I have no I dea what keeping the rotor on. I have soaked it with WD40(it has been soaking since last night, Soaked it again today too). I have been trying to nudge it off with a hammer, but don't want to hit it too hard.
I'm out of Ideas. I just soaked it down again with WD40 before coming to type up the post. Hoping I will hear the rotor crashing to the garage floor any minute now. But just in case it doesnt, anyone have any suggestions.
#4
#1 F0RUM TROLL
Thread Starter
Join Date: Mar 2002
Location: Naugatuck, CT
Posts: 1,132
Likes: 0
Received 0 Likes
on
0 Posts
Went wedieval with the hammer came off after about 10 minutes of pounding I was about the take the hub assembly off too. Well Time for the other side .
#7
Lives on the Forum
If the rotors are so stuck that they won't even come off when using the provided bolt hole try heating the hat area around the studs with a torch. Get the entire center section very hot and then try threading the bolt in. I bet they come off then.
Trending Topics
#8
Rotary on a budget
iTrader: (1)
Join Date: Sep 2003
Location: Austin, Tx
Posts: 823
Likes: 0
Received 0 Likes
on
0 Posts
well, the rotor stock has an extra screw hole to use one of the screw you drilled out, ...you insert it, hit it a fewt times with the impact whrech and there ya go
That worked for all but my rear right rotor, which i took a sledge to
That worked for all but my rear right rotor, which i took a sledge to
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM