what th points to set at 90 T2
I have a 90 S-5 T2 motor in my 82. Currently using a afc-1 wired to the map sensor before the fcd. Its set up that 40% is basically 0 on the boost gauge. I am running rc 750 and stock 550 with a walbro 255. I am only pulling out fuel on the low map at idle -10%. The set points are 55% and 65% Which kicks in the high map at roughly 7 psi. I am pulling some fuel out starting at 3k on the high map. -3% and works up to -16% at 7k.
My question is it pulls fine at 10 psi in third and fourth. I have a wideband and that how I dialed in my fourth gear pull. But in first and second its a dog, its falls on its face a lot. How do I keep my high map for third and fourth, and still dial in first and second. Is that possible, or is it standalone time. Thanks |
I had my high set point at 99% (~15PSI on the MAP)
The S-AFC can then work in the middle, between the low & high map, without going full rich too soon. I had a header dump right after the turbo. It really put some kick in the low gears. |
Ok i following what you are saying, what about the low throttle point setting.
Thanks |
I had my low point at 50% for better fuel economy.
If your setup wants to hesitate just a bit when you punch the throttle, you can try lowering it to 40 or 30% |
All times are GMT -5. The time now is 11:48 AM. |
© 2024 MH Sub I, LLC dba Internet Brands