safc2 with maps sensor for tps signal?
 

1st off i have never dealt with a safc2 so im new to it.

well im running a safc2 with the map sensor trick for the tps.
map sensor trick = using a map sensor output voltage for your tps signal
to the safc2, which = better gas milage and better preformance.

im using a 3rd gen rx-7 map sensor to use as my tps signal going to the safc2.
now my ? is,,, the safc2 has a self learning throttle test/set-up on it,
to do this test you are suppose to open the throttle wide open for 10 seconds then close it for ten seconds and it self learnes it.
so seeing in using a map sensor for my tps signal how do i go about doing this self leaning throttle set-up on the safc2?
do i just pressurize my map sensor to (x) amount of psi that im going to run and hold it at that for 10 seconds for it do the self learning test or what????

A nother ? for you...
also does anyone know were i can get info on psi's to voltage on a 3rd gen 2.2 bar rx-7 map sensor, or should i just start testing myself?
also any who has done this map sensor mod for there safc or know any member that could help would be greatly appreciated also.
thanks