T-stat housings
 

If anybody is in need of these we have them available. They allow for hood clearence on 20b's with FD water pumps, as well as clearance for 42R's on 13Bs

$295

nice piece.

what did you do about the coolant level sensor?

How far does this stick out in front of the waterpump pulley?

thanks
ryan

It will clear the hood and is about .5" infront of the pulley.

-S-

I got one. Yessss.

sean, can you post more pics from different angles? i need to figure out if it will work with my setup.

I unfortnately do not have any other pics taken :( I can get some more up on the next one. I install what are your concerns with fitment.

-S-

currently installing a vmount. wondering if this will protrude too far out to get in the way of the IC core.

It may, I will try and get one set up on a 2 rotor and let you know. If it does I may have another solution for you.

-S-

how many nipples does it have? will this also allow for different caps too?

It has one nipple for the overflow, and if requested one bung for the level sensor. I say requested because some people dont run a CL sensor. As far as caps go I would assume any standard cap would fit. I haven't tried too many I do know the greddy cap fit fine when tried.


-S-

Aside for the fitment issue with the stuff mentioned above is there any reason to run this in a fd with a 35r?

Does it allow for AST elimination like the FC housing?

Yes you can eliminate the AST, as for the FD with a 35R, other than looking the part and AST elimination not too sure.

do you still make these? pm sent.

answer your pms and email.

You could try calling the number on his web site:
(630) 825-0333

Sean i send you a pm regarding the t stat housing.
I need one very fast.
Please let us know when they are ready.
Im in for one with an extra bung for the coolant level sensor.
Thanks and just waiting for you guys

good luck, been waiting from a response from him for months.

I spoke with Sean on the phone; he's no longer offering the T-stat housings.