Wastegate piping size
I just dropped off my manifold to get the wastegate piping redone(creeping problems) and it has 1.5" pipe so would going to 1.75"pipe be enough or should i go to a 2" pipe?
|
Should be the size of your wastegate.
thewird |
the wastegate is a tial 44mm so 44mm converts into 1.73 inch. am i in the ball park?
|
yes it is 1.75" . I have that Tial wastegate.
|
I would assume the piping should match the flange. If your still having creeping problems, you should check the way your wastegate is hooked up or you need a bigger wastegate.
thewird |
I think the tial 44 inlet is 1.875" and outlet is 1.75"
|
I run 2" on all our TiAL 44's you want 2" if possible.
~S~ |
Originally Posted by Zero R
(Post 9826361)
I run 2" on all our TiAL 44's you want 2" if possible.
~S~ thewird |
old wastegate piping
http://i91.photobucket.com/albums/k3...6/PB070063.jpg New wastegate piping http://i91.photobucket.com/albums/k3...1267751285.jpg |
It's hard to tell from the picture of your new mani, but it looks like your exhaust stream must turn more than 90 deg to enter the wastegate circuit. This will cause restriction and is similar to running smaller tubing and/or a smaller wastegate. If you can correct this, your 44mm might be better able to control boost.
|
Originally Posted by elwood
(Post 9846483)
It's hard to tell from the picture of your new mani, but it looks like your exhaust stream must turn more than 90 deg to enter the wastegate circuit. This will cause restriction and is similar to running smaller tubing and/or a smaller wastegate. If you can correct this, your 44mm might be better able to control boost.
|
All times are GMT -5. The time now is 10:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands