Intake for single (fd)
 

I am nearing completion on my single project and am now buying the last few things I need to put on. One of which is an intake for the turbo. I was wondering if there is a rotary shop out there that has a intake for a single with the two vac nipples already on it? This is one of those cases where that is just a step I would rather pay for then do myself... so if you know of a shop out there with this available, please tell me.
Neal

anyone have any leads on this or can give hints on making one?

you could just get a local fabrication shop to make you one that meets all of your needs.

yeah,
I have just been lazy about this because I am working so much on the big stuff on the car that I thought I would splurge and just buy one...

So, my question is, does it need one or two vac nipples on it? I will not be running a catch can..

I'd run a catch can...

I just bought some bent 4" tube and cut it to the angle I wanted and tapped one vacuum nipple on it.

What's the other nipple for? OMP? I premix and recommend the same for high boost. more fuel = more lube

Im not going to be running high boost for a while... I want to get everything working right first and work on that later. Yes, I was going to run the other nipple for the omp.

Find the pipe that you want and make it fit. Hit the depot and pick up a brass barbed fitting to fit the hose you want to connect to your pipe.

http://www.mcmaster.com/catalog/111/...e/5670kp3l.gif



Also at the depot you'll find some rubber grommets. Size them so that the fitting barbs fit snugly inside. They usually have a plenty-pack witha small assortment. They look like this:

http://www.mcmaster.com/catalog/111/...e/9307kp1l.gif



Drill a hole in your pipe, insert the grommet. Trim one side of the fitting to only leave 2 barbs. Insert this side into your pipe. Install hose on the other side.

You're done.

https://www.rx7club.com/attachment.p...d=128948&stc=1


..Dave

^pretty cool idea...

thanks a bunch