holset turbo guys
 

i cant seem to figure out which vehicle to get the turbo off of, i found one today off of a 2001 dodge 2500 6 speed. does anybody know a specific vehicle to get one off of, im running a street port s4 turbo motor and 4 1600cc inj. going to run e85, probably try and get 400 at 1 bar. im guessing around 16cm rear housing and i would like to get between a 60-67mm front wheel. thanks btw, not sure as to which turbo to use, hx35 or hx40, using an hks cast mani with t4 open flange.

okay, found a cool place that tells you everything about which turbo is on what. anybody ever use the h1c?

Out of the H1 series that is the smallest exhaust wheel you can get.

If you are looking for a Holset turbo the odds are that you will not get one of a publicly available vehicle that does not carry a hot side that will impose "creative" installation challenges. The Holsets that most people are running are factory on industrial Cummins diesel applications.

If you need a Garrett comparison the H1E 3524034 is the biggest Holset H1E combo you can get and is in between the area (with regards to air flow and response) of the T-61 and the T-67.

So yes the H1C is an option, although not a very good one.

im not sure what to do, i cant find one, im thinking of just buying a used precision pt64e or pt67. just wanted to do the holset because a lot of people are very happy with them. let me know if you know any tricks to finding one that would work.

the one i found was from a tractor shop, i was talking to one of the guys i know, i forget the site but he found a place that was selling HX40 with t4 hot sides for around 500 bux. but i cannot remember the site.
but they can be found.
Rob

i will just have to keep looking, just need to find a turbo before may 7th

this hx52 is starting to look better and better by the minute.

idk this might help you might not. Im maxing out a hx35
http://z31performance.com/forum/viewtopic.php?f=1&t=249

My friend has an H2E I'm sure he'd be willing to part...

let me know what the specs are, im really in the need of a turbo, thanks for any help.

i got a WH1E and love it. 4 inch compressor inlet and 4in v-band exhaust. spools amazing also.

K cool, I'll grab the specs or just let him chime in...

whatever puts 400h.p. under my ass will suit me just fine. dont want to push it to much until my friend gets back from japan and shows me how to dowel this motor.

Yes, I am the one with the H2E.

What would you like to know?

http://www.citydiesel.net/

VERY knowledgeable staff, friendly, and fast shipping.

But buy netliv's turbo first!!!

besides the stuff i asked in the pm, did you ever use the turbo, what did you think of it?