High Horse Power + hub centric wheel spacers w/built in studs.
Are any of you guys with high HP rotary running these type of wheel spacers? My question is regarding proof of their strength. Are they holding up. I run the ichiba 25mm in the rear of my 400hp+ FD but am a little worried at this point since I am approaching 500hp. So far thy are holding. Do you advie against them at this power level?
Thought I should post it in this forum since most with high power visit here. |
wrong section by far.. also if your lugs are tight... they'll be perfectly fine.
|
if you are worried, there are two things you should be doing.
1. check the torque periodically. 2. upgrade to ARP studs. |
All times are GMT -5. The time now is 12:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands