Coolant feed line. Need Advice.
 

I'm starting to get all my lines together for my setup and I'm trying to figure out a way to make this work. There is about 1.5 inch distance from the nipple to the fitting.

http://farm9.staticflickr.com/8330/8...b7373499_b.jpg

I'll do some cutting if need be.

Any thoughts? Show me how you did it!

I usually delete that one( pull, tap and use a pipe plug) and then use the one on the top that goes to the throttle body( delete the throttle body circuit)

And cap off the line at the back of the block?

Figured it out. Thanks for the input over the phone, Elliot!