Banjo Bolt - Greddy T78 oil feed
 

Hey everyone, I was fixing the leaky oil feed on my T78-33d turbo and during the installation of new copper crush washers the banjo bolt broke in half. I had barely put any pressure on it and it popped right off, so i'm kind of thing the leak may have started because there was a crack in the bolt. I hadn't even tightened it down enough to pull out the torque wrench to give it the final few turns.

Does anyone know the specs on this bolt and where I can find one? I've been googling and am having trouble finding something similar.

I'm pretty sure its a 10mm x 1.25 (i fount a thread on here about it). But the height from the bottom of the threads to the underside of the hex head is about 28mm. Everything I'm seeing online is a lot shorter.

Can anyone help? I was really hoping to have it up and running this weekend.

Thanks,
-Collin

Collin, if you have a local hydraulic shop nearby they will have it for sure. Other than that just go to napa, my parts books shows the banjo bolt 10mm 1.25 pitch...

summitracing.com

i got mine from rx7store.net.. its a bitch to find casue you have to go to turbos then to turbo accessories.. but there in there

Thanks guys, I actually found one at Jegs last night. Finding the right type is pretty difficult, most seem to be made for brakes.