RX7Club.com - Mazda RX7 Forum - Search Results

 
Search: Posts Made By: SlidinRX7
Showing results 1 to 25 of 101
Search took 0.29 seconds.
03-11-07, 03:27 PM
Replies: 7
Views: 539
Posted By SlidinRX7

Something similar to this happen to me a few...

Something similar to this happen to me a few years ago. My headlight switch actually shorted out in the back. It caused a part of the harness that plugs into the switch to burn a little. I swapped in...
02-22-07, 04:24 AM
Replies: 132
Views: 22,979
Posted By SlidinRX7

Ah, yes. My SP1's did require rolling of my...

Ah, yes. My SP1's did require rolling of my fenders, but only in the front. The back fit perfect with no problems. I was actually thinking about going with a 255 in the rear since there's still a...
02-22-07, 03:58 AM
Replies: 18
Views: 2,334
Posted By SlidinRX7

My old S5 used to pop blue flames at idle, but it...

My old S5 used to pop blue flames at idle, but it was because I had a blown apex seal and I was trying to limp it off the track lol. When everything was running all good it would only pop tiny flames...
02-22-07, 01:35 AM
Replies: 132
Views: 22,979
Posted By SlidinRX7

SSR SP1 Professor's 17x8 235/45 and 17x9 245/40...

SSR SP1 Professor's 17x8 235/45 and 17x9 245/40 with +37 offset all around. Currently running Intrax springs with Tokico blue's.
http://img.photobucket.com/albums/v427/x808fcx/P1010088.jpg...
02-22-07, 01:04 AM
Replies: 4
Views: 484
Posted By SlidinRX7

Should be a direct bolt up. I swapped a S4 GXL...

Should be a direct bolt up. I swapped a S4 GXL LSD into my old S5 GTU with no problems. Just had a hell of time getting bolted up. It was my first time taking out the LSD at the time. Since you're...
10-24-06, 03:53 AM
Replies: 11
Views: 570
Posted By SlidinRX7

To me it sounds like you're talking about the...

To me it sounds like you're talking about the sway bar endlinks, I could be wrong though. If that's the case, you should try check Mazdatrix. They offer the endlinks for $66.80 for the pair......
10-19-05, 12:52 AM
Replies: 17
Views: 589
Posted By SlidinRX7

That is true, there is noticable camber on stock...

That is true, there is noticable camber on stock FC's. Camber adustment parts can help correct it. When my friend put the camber rod on his car it corrected it, but at the same time it the toe was...
04-07-05, 06:32 PM
Replies: 11
Views: 831
Posted By SlidinRX7

If you hooked up the SAFC up properly, using the...

If you hooked up the SAFC up properly, using the wiring diagram provided with the SAFC, then everything should be alright. When I swapped my TII into my NA, the SAFC read the TPS differently. All I...
03-07-05, 02:39 AM
Replies: 10
Views: 754
Posted By SlidinRX7

Check to make sure you have power steering fluid...

Check to make sure you have power steering fluid in the resevior. Then have a friend turn the steering wheel while you stand in front of the engine bay. If the power steering pump is bad, then it'll...
03-07-05, 02:31 AM
Replies: 15
Views: 572
Posted By SlidinRX7

If you are going to put FD rims on, don't forget...

If you are going to put FD rims on, don't forget to use spacers and extended lug studs(if not using bolt on spacers).
03-07-05, 02:18 AM
Replies: 10
Views: 754
Posted By SlidinRX7

If you mean when you turn the steering wheel,...

If you mean when you turn the steering wheel, then it could be the power steering pump is bad. It happened to me before. You can try and use the Lucas power steering oil. IMHO, it's only a temporary...
02-04-05, 01:24 AM
Replies: 18
Views: 623
Posted By SlidinRX7

They work pretty good. Well I don't have the ebay...

They work pretty good. Well I don't have the ebay brand, but I'm using H4 housings with some Mtek(don't remmeber...) bulbs and they are really bright. The thing is though, if you use the H4 housings...
02-03-05, 03:17 PM
Replies: 3
Views: 452
Posted By SlidinRX7

anyone...?

anyone...?
02-03-05, 12:59 AM
Replies: 3
Views: 452
Posted By SlidinRX7

The motor has the TII CAS inside. What I was just...

The motor has the TII CAS inside. What I was just thinking about is that the TII CAS and the NA CAS is calibrated differently. Should I try putting in the NA CAS? Also, are the TII sensors calibrated...
02-02-05, 11:21 PM
Replies: 3
Views: 452
Posted By SlidinRX7

TII swap into S5 NA...not your typical problem

Well I swapped a S5 TII block and manifold into my S5 NA using my NA drivetrain. The catch is that I'm going to keep it NA for now so I can drive it around. I'm still waiting on some parts and I have...
12-10-04, 02:23 AM
Replies: 2
Views: 928
Posted By SlidinRX7

The easiest way would be to take off the hub and...

The easiest way would be to take off the hub and get them pressed in with a hydraulic press. It's fairly easy to remove the hub...remove caliper, take off brake rotor, dust shield, cotter pin, then...
12-10-04, 02:05 AM
Replies: 6
Views: 657
Posted By SlidinRX7

Those are drop springs, NOT coilover springs. All...

Those are drop springs, NOT coilover springs. All it does is replace the stock spring. If you're still using stock/OEM replacement struts, then dropping the car might damage the seals inside the...
11-17-04, 01:37 AM
Replies: 23
Views: 959
Posted By SlidinRX7

I'm running BBS 17x8 (40+ offset) all around,...

I'm running BBS 17x8 (40+ offset) all around, 205/50 in the front and 235/45 in the rear. I got TEIN Type HA coilovers dropped a little past the "recommended height" and there is no rubbing. Although...
10-29-04, 11:10 PM
Replies: 5
Views: 540
Posted By SlidinRX7

What are you building the car for?

What are you building the car for?
05-29-04, 04:16 AM
Replies: 9
Views: 500
Posted By SlidinRX7

I have an extra one. PM me if you want it. ...

I have an extra one. PM me if you want it.

Vance
03-16-04, 12:26 PM
Replies: 4
Views: 1,382
Posted By SlidinRX7

Well, what I did when I put on my underdrive...

Well, what I did when I put on my underdrive pulley was get big pipe wrench, a 1/2" drive breaker bar, two very long and very strong pipes, and a friend to help me out. First take off the pulley...
03-04-04, 11:20 PM
Replies: 5
Views: 477
Posted By SlidinRX7

Well if you want something fairly cheap, a set of...

Well if you want something fairly cheap, a set of Racing Beat drop springs and KYB AGX adjustable struts. This way you can change your struts according to what you're doing, eg. AutoX, Drag, Drift,...
01-23-04, 07:50 AM
Replies: 60
Views: 3,513
Posted By SlidinRX7

My friend had bought one for his 240 and the...

My friend had bought one for his 240 and the thing was total crap. As soon as he got it he put it on his car and the damn thing didn't fit right. It sat so close to the valve cover that it now has a...
12-08-03, 08:09 PM
Replies: 30
Views: 881
Posted By SlidinRX7

Just out of curiousity, what are you running on...

Just out of curiousity, what are you running on the 1/4 mile now?
11-18-03, 11:36 PM
Replies: 14
Views: 596
Posted By SlidinRX7

Tear apart the motor and port it, throw a light...

Tear apart the motor and port it, throw a light weight flywheel, underdrive pulley, ported intake, 4.30 rearend, S-AFC, good tires, and most of all a good driver.

There's a lot of things you can...
Showing results 1 to 25 of 101
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.